How to maintain the tripod attachment?

The maintenance of tripod attachment should focus on the cleaning and lubrication of key components. The specific methods are as follows:
Foot tube maintenance
Cleaning steps: Use an air blower to remove surface dust, use a toothbrush dipped in soapy water to clean the joints, and then dry them with a cloth. If exposed to corrosive environments such as sediment and seawater, rinse with clean water and air dry. Carbon fiber material foot tubes should be stored vertically to avoid deformation caused by horizontal placement
Lubrication maintenance: Apply waterproof grease to the threads (do not apply plastic parts), pay attention to the order of parts and the direction of gaskets during loading and unloading, and avoid damage caused by over tightening. ‌
PTZ and quick installation board
Locking check: Before use, confirm the locking status of the gimbal to avoid shaking while walking. Plastic bags can be used for protection in windy and sandy environments to prevent sand particles from entering and affecting rotation. ‌
Quick installation board cleaning: After disassembly, wipe the metal contacts with a soft cloth to avoid poor contact caused by oil stains or gravel residue. ‌
Foot pads and storage
Rubber foot pad: When it is dirty, it should be disassembled and soaked for cleaning. When installing, ensure that it is in close contact with the ground to prevent slipping. ‌
Storage method: Long term storage should be placed in a dedicated storage bag or toolbox to avoid deformation caused by compression. Thoroughly wipe off surface stains and check for loose screws before storage. ‌
Special environmental treatment
After rain, snow/sandstorms: Immediately wipe with a dry cloth and air dry to avoid metal fatigue caused by alternating cold and hot parts or strong rotation. ‌
Extreme weather: Avoid direct contact with water stains during ice and snow weather, and ensure complete dryness before storage.