The light engraving and milling machines factory is formulated with water-based materials, does not contain mineral oil, and does not contain sodium nitrite. No oil mist is produced during use, and it is harmless to the human body. It greatly improves the working environment and improves the process performance of light engraving and milling machines factory. It is especially suitable for the processing of workpieces with large thickness, large taper, and high finish. The black working fluid is splashing everywhere, the moist oil mist fills the space, and the dirty and harsh processing environment is almost a standard portrayal of the light engraving and milling machines factory processing industry! The processed surface of the workpiece turns black, and the efficiency of cutting large workpieces is significantly reduced. These are common problems in most light engraving and milling machines factories! Over the years, countless people have tried countless times to change this environment and even escape from this processing magic circle. Today everything has changed with the birth of Runkang rk-1light engraving and milling machines factory working fluid.

1. Improvement of process performance:

(1) Improved the finish of the workpiece: The use of rk-1light engraving and milling machines factory working fluid can improve the surface finish of the workpiece by half a level, making the surface of the workpiece brighter and whiter, while reducing molybdenum wire loss;

(2) Improve the processing efficiency of soft materials such as copper and aluminum: rk—1light engraving and milling machines factory working fluid greatly improves the processing efficiency of light engraving and milling machines factory, especially when processing soft materials such as copper and aluminum. There is no "patina" phenomenon, chip removal is smooth, cutting is smooth, and the processing efficiency is increased by about 30%.

(3) Improve the processing efficiency of large-thickness workpieces: When cutting 300-400mm workpieces, rk-1light engraving and milling machines factory has strong working fluid separation ability, corrosives are easy to settle, the water quality is transparent, and the processing efficiency and processing stability are simultaneously improved. When cutting workpieces with a thickness of 500-1000mm, general cutting fluids will cause broken wires, short circuits, low efficiency and even inability to process. In this case, this working fluid is necessary.

2. The service life and cost performance are significantly improved:

After rk-1light engraving and milling machines factory working fluid is used for 60 hours, it can be directly replenished with clean water and working fluid. The repeated service life is as long as 1 to 2 months, which significantly saves costs.

light engraving and milling machines factory https://www.talentcnc.com/aiproduct-item-248.html